Ask Toronto Certified Eco-Tek Flooring Installers

For new construction $14-$16 per square foot is a good budgetary number. When comparing to tile remember with Eco-Tek you will not have the cost of labor and materials for installing a waterproofing membrane, cementitious wall board, Portland mud set, or the continual maintenance of re-grouting. If you have an existing location with flooring issues, we can repair those failed areas and install directly over the remaining floor. This price will vary due to the amount of prep work required, but these installations are performed during off hours to avoid any loss of revenue during the floor installation

For the most part no, however often prep work which involves grinding will create noise and some dust. Precautions are taken to contain and minimize the dust.

Kitchen will need to be shut down for the duration of the work. All equipment needs to be disconnected and moved out of the working area.

There are no set out standards, it will depend on the amount of prep work required, complexity of the space, and ease of access.

No, flooring installations require factory-trained installers to insure that all installation procedures have been followed and that is the only way we can extend a 10 year warranty.

Eco-Tek has been certified by the National Floor Safety Institute with a coefficient of friction result of 1.07 when wet, exceeding ADA and OSHA standards. (Rating is out of 1.0)

Eco-Tek is 1/4″ thick

We will scrape any of the loose areas of the epoxy that are pealing up, grind the surface of the floor, and finally skim coat areas as needed. Once this process is completed we will degrease the floor and install your new Eco-Tek floor.

Eco-Tek utilizes a flash cove baseboard that folds up the walls to eliminate the normal moisture related failure point of where the floor meets the baseboard. Once the Eco-Tek flooring system is installed you will have a complete waterproof environment.

Eco-Tek can be installed over virtually any type of substrate as long as it is sound and not holding water. With a gypcrete substrate, we would use a special one-part waterproof mastic instead of our standard two-part epoxy. Eco-Tek is routinely installed over plywood, concrete, hardwood, brick pavers and metal.

Having a consistent cleaning process is critical to maintaining the quality of any type of floor. You want to make sure that you are using the correct products and cleaning procedures to eliminate the accumulation of oil and grease. When these types of containments are allowed to build up they will affect the performance of the flooring.